Magnum-venus-plastech System One FRP 4102-00-01 Manual do Utilizador

FRP SystemOneMaintenance & Repair ManualMAGNUM VENUS PRODUCTSFRP SystemOne 4102-00-01 Metering PumpPart No. M6704-2-1Revision 06.25.01

FRP SystemOne714. Install the 7304-1-1 (Piston Seal) onto the treaded end of the4102-7-1 (Piston Body) spring side up.15. Install the 4102-8-1 (Piston

FRP SystemOne820. Place the 9201-1-7 (7/32” SS Ball) down inside the 4101-15-1(Check Valve Body) through the double threaded side.21. Install the 4101

FRP SystemOneFRP SystemOneCatalyst Surge Chamber ReassemblyChapter51. Install a 7301-9-013 (O-Ring) over the threaded end of the 4104-6-1(Return Tube

FRP SystemOneFRP SystemOneParts DrawingsChapter610

FRP SystemOne11MAGNUM VENUS PRODUCTS

FRP SystemOneThe parts for this repair kit areincluded in the Metering PumpRepair Kit, PN 6702-5-112

FRP SystemOne13MAGNUM VENUS PRODUCTS

FRP SystemOne14

FRP SystemOne15MAGNUM VENUS PRODUCTS

FRP SystemOne16

FRP SystemOneFRP SystemOneMaintenance & Repair ManualMetering Pump ModuleMAGNUM VENUS PRODUCTS1862 Ives Avenue, Kent, WA 98032 USAPhone: (253) 854

FRP SystemOne17MAGNUM VENUS PRODUCTS

FRP SystemOne18

FRP SystemOne

FRP SystemOne

FRP SystemOneMAGNUM VENUS PRODUCTS1862 Ives Avenue, Kent, WA 98032 USAPhone: (253) 854-2660 (800) 448-6035Fax: (253) 854-1666Email: info@venusmagnu

FRP SystemOneCHAPTER 1 - GETTING STARTEDTools RequiredCHAPTER 2 - INSTRUCTIONSDisassembly of Metering PumpCHAPTER 3 - INSTRUCTIONSDisassembly of

FRP SystemOne1FRP SystemOneMetering PumpGetting StartedTools Required1. 1” Open End Wrench2. 3/4” Open End Wrench3. 5/8” Open End Wrench4. 6” Adjustab

FRP SystemOneFRP SystemOneDisassembly of Metering Pump2Chapter21. Remove 4101-15-1 (Check Valve Body) from 4101-14-1 (OutletBody) and remove and disca

FRP SystemOne7. Remove and discard the 9201-1-5 (5/32” SS Ball).8. Remove and retain the 4101-3-1 (Piston Rod Spring).9. Unscrew the 4102-3-1 (Packing

FRP SystemOne4FRP SystemOneCatalyst Surge Chamber DisassemblyChapter31. Loosen the 4101-18-1 (Jam Nut), and remove the 4104-7-1 (GaugeAdapter) from th

FRP SystemOneFRP SystemOneReassembly ofMetering PumpAssembly Procedures:1. Install 7301-9-013 (O-Ring), and 4101-8-1 (Inlet Tube Fitting) onto4101-7-1

FRP SystemOne65. Thread the 4101-1-1 (Lock Nut) onto the 4102-6-1 (Cylinder) until itbottoms on the Cylinder shoulder.6. Install a 7301-9-014 (O-Ring)