Magnum-venus-plastech APS FIT-C-APS-3 Manual do Utilizador

Maintenance & Repair ManualMAGNUM VENUS PRODUCTSAPS FIT Chop SystemFIT-C-APS-3 Maintenance & RepairPart No. FIT-C-APS-3Revision 05.14.04

13. Select End Plate (Dead): End plate with threads in hub. When assembled, kidney ports in endplates must be on intake side.14. Assemble End Plate

Chapter4Cautions and WarningsAIRLESS EQUIPMENT SAFETYInjection Hazard• DO NOT POINT THE GUN AT ANY PERSON• NEVER LOOK AT THE GUN FROM THE FRONT (NOZZL

Correct packing or valve seal leaks IMMEDIATELY.Frequently check the condition of all pressurized components, especailly fluid lines. Replace worn li

Filtered and oiled air will allow the pump to operate more efficiently and yield a longer life to operating partsand mechanisms.Keep oiler supplied wi

Chapter5Parts Drawings

APS FIT Chop SystemMaintenance & Repair Manual© 2004 Magnum Venus Products Manual Part No: FIT-C-APS-3Corporate HQ & Mfg.Phone: (727) 573-2955

CHAPTER 1 - BASIC TROUBLE SHOOTING GUIDESHPC-1000 Slave PumpFluid SectionsChoppersCHAPTER 2 - RC-1000 & RC-1101-1 ROVING CUTTER INSTRUCTIONSCHAP

ProblemNo catalyst coming fromgun.Catalyst spitting from gun.No catalyst flow on downstroke of catalyst pump.No catalyst flow on upstrokeof catalyst p

ProblemFast downstroke (winking ofpattern).Fast upstroke (winking ofpattern).Partial dive on downstroke.Pump stroke “chatter”.Material leakage intosol

© 2004 Magnum Venus Products Manual Part No: FIT-C-APS-3Corporate HQ & Mfg.Phone: (727) 573-2955Fax: (727) 571-3636MVP Technology CenterPhone: (25

BASIC TROUBLE SHOOTING GUIDE FOR CHOPPERSProblemCutter not shutting off.Cutter does not come on.Glass binds up.Improper chop length.Cutter running too

Chapter2RC-1000 & RC-110101Roving Cutter InstructionsRC-1000The RC-1000 cutter was designed to cut glass roving into short lengths of 1/2” to 4”,

Cutter Adjustment: The glass should enter the resin fan as soon as possible without excessive glassfallout. Normally, if the glass enters the resin

RC-1101-1 ASSEMBLY OF AIR MOTOR1. Remove Burrs: With fine file or emery cloth.2. End Clearance: Average end clearance .0015” to .002”. To get end