Maintenance & Repair ManualMAGNUM VENUS PRODUCTSAPS FIT Chop SystemFIT-F-CMB-APS-6 Maintenance & RepairPart No. FIT-F-CMB-APS-6Revision 04.27
13. Select End Plate (Dead): End plate with threads in hub. When assembled, kidney ports in endplates must be on intake side.14. Assemble End Plate
Chapter4Cautions and WarningsAIRLESS EQUIPMENT SAFETYInjection Hazard• DO NOT POINT THE GUN AT ANY PERSON• NEVER LOOK AT THE GUN FROM THE FRONT (NOZZL
Correct packing or valve seal leaks IMMEDIATELY.Frequently check the condition of all pressurized components, especailly fluid lines. Replace worn li
Filtered and oiled air will allow the pump to operate more efficiently and yield a longer life to operating partsand mechanisms.Keep oiler supplied wi
Chapter5Parts Drawings
APS FIT Chop SystemMaintenance & Repair Manual© 2004 Magnum Venus Products Manual Part No: FIT-F-CMB-APS-6Corporate HQ & Mfg.Phone: (727) 573-
CHAPTER 1 - BASIC TROUBLE SHOOTING GUIDESHPC-1000 Slave PumpFluid SectionsChoppersCHAPTER 2 - RC-1000 & RC-1101-1 ROVING CUTTER INSTRUCTIONSCHAP
ProblemNo catalyst coming fromgun.Catalyst spitting from gun.No catalyst flow on downstroke of catalyst pump.No catalyst flow on upstrokeof catalyst p
ProblemFast downstroke (winking ofpattern).Fast upstroke (winking ofpattern).Partial dive on downstroke.Pump stroke “chatter”.Material leakage intosol
© 2004 Magnum Venus Products Manual Part No: FIT-F-CMB-APS-6Corporate HQ & Mfg.Phone: (727) 573-2955Fax: (727) 571-3636MVP Technology CenterPhone:
BASIC TROUBLE SHOOTING GUIDE FOR CHOPPERSProblemCutter not shutting off.Cutter does not come on.Glass binds up.Improper chop length.Cutter running too
Chapter2RC-1000 & RC-110101Roving Cutter InstructionsRC-1000The RC-1000 cutter was designed to cut glass roving into short lengths of 1/2” to 4”,
Cutter Adjustment: The glass should enter the resin fan as soon as possible without excessive glassfallout. Normally, if the glass enters the resin
RC-1101-1 ASSEMBLY OF AIR MOTOR1. Remove Burrs: With fine file or emery cloth.2. End Clearance: Average end clearance .0015” to .002”. To get end
Comentários a estes Manuais