Magnum-venus-plastech CB-6000-RGT Metric Units PROGRAMMING Manual do Utilizador

MAGNUM VENUS PRODUCTS PROGRAMMING MANUAL – CB-6000-RGT PROGRAMMING MANUAL (Metric Units) CB-6000-RGT

9 This is a test mode for the panel buttons. Push the INCREMENT/ON button and the display will change to this: Push the DECREMENT/OFF butto

10 Step 14) Push the Down Cursor button again and the display will change to this: This is a panel display test to check for any LED elements

11 Part 2 Resin Total Meter programming: The Resin Total Meter is pre-programmed by MVP at the factory. All values that appear on the display must

12 Step 4) Push the DOWN CURSOR button and the display will change to this: Step 5) Push the DOWN CURSOR button and the display will

13 NOTE: The calibration number must be multiplied by the corresponding decimal point used in step 6. See example etc. with Chart B. At this p

14 Step 8) Push the DOWN CURSOR button and the display will change to this: Step 9) Push the DOWN CURSOR button and the display will

15 Step 13) Push the DOWN CURSOR button and the display will change to this: Push the RUN/PROGRAM button to return to the operating mo

16 Part 3 Glass Rate Meter programming: All programming is accomplished from the front panel of the Glass Rate Meter. The programming sequence for

17 To determine the Glass Rate Meter calibration number for any glass yield not given in charts C and D calculate the calibration number as the examp

18 Part 4 Glass Total Meter programming: All programming is accomplished from the front panel of the Glass Total Meter. The programming sequence fo

1 Preface: The MVP CB-6000-RT Resin / Glass Monitor is a four display unit for monitoring the material throughput of a specific MVP GFRP production

19 To determine the Glass Total Meter calibration number for any glass Tex not given in charts E and F calculate the calibration number as the exampl

20 Part 5 Troubleshooting: 1) If nothing happens when the unit is powered up, check the fuse on the back of the unit. If it is good, check to make

2 PART 1 Resin Rate Meter programming... Page 3 PART 2 Resin Total Meter programming... Page 11 PART 3 Glass Rate Meter pr

3 Resin Rate Meter programming (Metric) All programming is accomplished from the front panel of the Resin Rate Meter. There are a series of switche

4 To determine the calibration number for a specific gravity that does not appear in Chart A simply multiply the specific gravity of the resin by

5 Step 1) Turn the front panel power switch off. Step 2) Connect power (100 to 125 VAC, 50/60 Hz, 6 VA) to the unit and turn the power switch on.

6 be highlighted. By pushing the INCREMENT/ON or the DECREMENT/OFF buttons you can increase or decrease the value of the highlighted digi

7 This is the calibration number for a MVP HVLS high volume resin pump with a resin specific gravity of 1.08 and is preset at MVP. To change this n

8 Step 9) Pushing the Down Cursor button will change the display to look like this: This step allows you to select the type of output signal y