Magnum-venus-plastech Pro Rider Gel Coater Manual do Utilizador

Pro Rider Gel Coater Operations Manual Rev. 09/2012

Pro Rider Operations Manual Rev. 09/2012 Page | 10 When all three elements are present, the result can be an extremely violent explosion. The react

Pro Rider Operations Manual Rev. 09/2012 Page | 11 G. Adequate ventilation (as covered in OSHA Section 1910.94 and NFPA No.91) is important wherever

Pro Rider Operations Manual Rev. 09/2012 Page | 12 2.7 Toxicity of Chemicals A. Magnum Venus Plastech recommends that you consult OSHA Sections 1910

Pro Rider Operations Manual Rev. 09/2012 Page | 13 3.0 Equipment Safety WARNING Magnum Venus Plastech suggests that personal safety equipment such a

Pro Rider Operations Manual Rev. 09/2012 Page | 14 3.2 Grounding Grounding an object means providing an adequate path for the flow of the electrical

Pro Rider Operations Manual Rev. 09/2012 Page | 15 Introduction: This manual provides information needed to properly operate and perform simple ma

Pro Rider Operations Manual Rev. 09/2012 Page | 16 Getting Started: Air Requirements: Clean, dry compressed air must be available at 90 – 100 psi

Pro Rider Operations Manual Rev. 09/2012 Page | 17 Installation and Setup: 1. Unpack unit & components – report any damaged or missing items

Pro Rider Operations Manual Rev. 09/2012 Page | 18 Priming the Unit: Priming Gel Coat to Gun: NOTE: The resin pump was tested using oil. It may

Pro Rider Operations Manual Rev. 09/2012 Page | 19 3. Fill the catalyst jug ¾ full, purge the air out of the catalyst feed line by slightly tiltin

Pro Rider Operations Manual Rev. 09/2012 Page | 2 CORPORATE HEADQUARTERS and MANUFACTURING 11692 56th Court * Clearwater, FL 33760 * Tel 7

Pro Rider Operations Manual Rev. 09/2012 Page | 20 Daily Start-up & Shut-down: Daily Start-Up: 1. Check all hoses for damage. 2. Check all

Pro Rider Operations Manual Rev. 09/2012 Page | 21 Trouble Shooting Guide: The most common problems with the equipment are diagnosed by analyzing t

Pro Rider Operations Manual Rev. 09/2012 Page | 22 PROBLEM CAUSE SOLUTION Air lock in catalyst pump. Remove air lock. See Appendix: Air Lock in th

Pro Rider Operations Manual Rev. 09/2012 Page | 23 PROBLEM CAUSE SOLUTION Resin hose plugged. Danger: To prevent injury, always relieve fluid p

Pro Rider Operations Manual Rev. 09/2012 Page | 24 PROBLEM CAUSE SOLUTION Pump dives on down stroke Foot valve, spring retainer, or foot valve

Pro Rider Operations Manual Rev. 09/2012 Page | 25 PROBLEM CAUSE SOLUTION Fitting or nipple damaged. Danger: To prevent injury

Pro Rider Operations Manual Rev. 09/2012 Page | 26 Basic Troubleshooting for AT Guns: Problem Possible Cause(s) Recommended Solution Air leaking

Pro Rider Operations Manual Rev. 09/2012 Page | 27 Material is leaking from weep hole on material side of gun. Loose diffuser seat. Adjust until sn

Pro Rider Operations Manual Rev. 09/2012 Page | 28 Catalyst Pump - Air Lock: DANGER: Fluids under High Pressure. Before performing any service an

Pro Rider Operations Manual Rev. 09/2012 Page | 29 Optional Process: The air bubble can be quickly removed if the PRO-RECIRC option is installed on

Pro Rider Operations Manual Rev. 09/2012 Page | 3 Table of Contents SECTION: Page TERMS & CONDITIONS OF SALE 4 SAFETY

Pro Rider Operations Manual Rev. 09/2012 Page | 30 Pump Repair Procedures: The Pro Rider Gel Coat system uses the VPRO-45220-NPR Pump assembly – f

Pro Rider Operations Manual Rev. 09/2012 Page | 31 Catalyst Pump Repair: The Pro Rider Gel Coat system uses the PCP-2000-RV-PR Catalyst Pump assemb

Pro Rider Operations Manual Rev. 09/2012 Page | 32 Gel Coat Gun Repair: The Pro Rider Gel Coat system comes standard the ATG-3500 Gel Coat Assembl

Pro Rider Operations Manual Rev. 09/2012 Page | 33 Parts Drawings: PRO-RIDER 22:1 PRO RIDER GEL COATER MA-NPR-ATG PRO RIDER AIR MANIFOLD –

Pro Rider Operations Manual Rev. 09/2012 Page | 34 MAGNUM VENUS PRODUCTS22 : 1 PRO RIDER PUMPPRO-RIDERREV. - 11/03/05 BT2222119100500100017

Pro Rider Operations Manual Rev. 09/2012 Page | 35 1VPRO-45220-NPR 1 PRO PUMP ASSY22 : 1 PRO RIDER PUMP PRO-RIDERQTYPARTS LISTITEMPART

Pro Rider Operations Manual Rev. 09/2012 Page | 36 Air Manifold for Pro RiderMAGNUM VENUS PRODUCTSREV - 09/01/06 BT2MA-NPR-ATG9534138171018REV

Pro Rider Operations Manual Rev. 09/2012 Page | 37 DESCRIPTIONPART NO.ITEMPARTS LISTQTYAIR MANIFOLD - PRO RIDER MA-NPR-ATG1HA-0666-31AIR HOSE227

Pro Rider Operations Manual Rev. 09/2012 Page | 38 CATALYST JUG FOR PRO RIDERMAGNUM VENUS PRODUCTSREV - 06-28-05 BT2NPR-1054-ASY33

Pro Rider Operations Manual Rev. 09/2012 Page | 39 DESCRIPTIONPART NO.ITEMPARTS LISTQTYCATALYST JUG NPR-1054-ASY2MS-1017 1 FILTER1PR-1054 1 BOT

Pro Rider Operations Manual Rev. 09/2012 Page | 4 Terms & Conditions of Sale: • Customs duties, import and export licenses and certificates, i

Pro Rider Operations Manual Rev. 09/2012 Page | 40 Fluid Filter for Pro RiderMAGNUM VENUS PRODUCTSREV A - ITEM 7 WAS QTY. OF 2, ITEM 10 WAS PF-RB-08

Pro Rider Operations Manual Rev. 09/2012 Page | 41 DESCRIPTIONPART NO.ITEMPARTS LISTQTYFluid Filter - Pro Rider FF-NPR-1002FF-5002 1FILTER CAP1P

Pro Rider Operations Manual Rev. 09/2012 Page | 42 Air Manifold for Pro RiderMAGNUM VENUS PRODUCTSREV - 06/29/05 BT2MA-NPR9534138171018

Pro Rider Operations Manual Rev. 09/2012 Page | 43 DESCRIPTIONPART NO.ITEMPARTS LISTQTYAIR MANIFOLD - PRO RIDER MA-NPR1HA-0666-3 1 AIR HOSE22770

Pro Rider Operations Manual Rev. 09/2012 Page | 44 Revision Information: Rev. 04/2010 Assembled This Manual Rev: 09/2012 Updated the manual fo

Pro Rider Operations Manual Rev. 09/2012 Page | 45 MAGNUM VENUS PLASTECH CORPORATE HEADQUARTERS and MANUFACTURING 11692 56th Court * Clearwat

Pro Rider Operations Manual Rev. 09/2012 Page | 5 against the Seller in respect of the goods, the liability of the Seller shall be limited to the va

Pro Rider Operations Manual Rev. 09/2012 Page | 6 SAFETY & WARNING INFORMATION: OPERATING YOUR POLYESTER SYSTEM SAFELY 1. Introduction Any tool,

Pro Rider Operations Manual Rev. 09/2012 Page | 7 Type of Fire Extinguishing equipment recommended: Fire Extinguisher – code ABC, rating number 4a60

Pro Rider Operations Manual Rev. 09/2012 Page | 8 2.2 Catalyst (Methyl Ethyl Ketone Peroxide) MEKP is among the more hazardous materials found in co

Pro Rider Operations Manual Rev. 09/2012 Page | 9 C. Prevent contamination of MEKP with other materials, including polyester over spray and sandings